• Please note: In an effort to ensure that all of our users feel welcome on our forums, we’ve updated our forum rules. You can review the updated rules here: http://forums.wolflair.com/showthread.php?t=5528.

    If a fellow Community member is not following the forum rules, please report the post by clicking the Report button (the red yield sign on the left) located on every post. This will notify the moderators directly. If you have any questions about these new rules, please contact support@wolflair.com.

    - The Lone Wolf Development Team

WHFB version wfbv6v41 and disappearing files.

  • Thread starter Thread starter lorne at iinet.net.au
  • Start date Start date
L

lorne at iinet.net.au

Guest
I have tried to install the latest WHFB files over the last couple of
days and have had the files disappear on me after installation. The
error message is:

failed to load data files for the following reason. Version
unrecognised in data file c:\armybuilder\data\me.wf6

It worked OK for version 3.x and was OK for ver 4.0 but when I
installed 4.1 is didn't recognise the system. I then reinstalled 3.2
and it worked fine. However when installing either 4.0 or 4.1 the
same problem started all over again.

Help.


------------------------ Yahoo! Groups Sponsor ---------------------~-~>
eGroups is now Yahoo! Groups
Click here for more details
http://click.egroups.com/1/11231/0/_/36190/_/980668571/
---------------------------------------------------------------------_->

To unsubscribe from this group, email

armybuilder-unsubscribe@egroups.com
 
Have you upgraded to V2.1 yet? The latest WFB data files require you have
V2.1. It a FREE update from the web-site if you have V2.0 already.

Thanks, Rob


At 07:56 AM 1/28/01 +0000, you wrote:
>I have tried to install the latest WHFB files over the last couple of
>days and have had the files disappear on me after installation. The
>error message is:
>
>failed to load data files for the following reason. Version
>unrecognised in data file c:\armybuilder\data\me.wf6
>
>It worked OK for version 3.x and was OK for ver 4.0 but when I
>installed 4.1 is didn't recognise the system. I then reinstalled 3.2
>and it worked fine. However when installing either 4.0 or 4.1 the
>same problem started all over again.
>
>Help.


---------------------------------------------------------------------------
Rob Bowes (rob@wolflair.com) (650) 726-9689
Lone Wolf Development www.wolflair.com


------------------------ Yahoo! Groups Sponsor ---------------------~-~>
eGroups is now Yahoo! Groups
Click here for more details
http://click.egroups.com/1/11231/0/_/36190/_/980670847/
---------------------------------------------------------------------_->

To unsubscribe from this group, email

armybuilder-unsubscribe@egroups.com
 
You must log in or register to reply here.
Back
Top