• Please note: In an effort to ensure that all of our users feel welcome on our forums, we’ve updated our forum rules. You can review the updated rules here: http://forums.wolflair.com/showthread.php?t=5528.

    If a fellow Community member is not following the forum rules, please report the post by clicking the Report button (the red yield sign on the left) located on every post. This will notify the moderators directly. If you have any questions about these new rules, please contact support@wolflair.com.

    - The Lone Wolf Development Team

Help with point cost adjustment.

R

ratboy

Well-known member
In adding a new set to the SW CMG files, I've come upon a dilemma.

FIG A makes FIG B cost 1 less when they are in the same [deck].

I just can't seem to figure out how to implement this.
 
At 02:40 AM 9/26/2005 -0400, you wrote:

>In adding a new set to the SW CMG files, I've come upon a dilemma.
>
>FIG A makes FIG B cost 1 less when they are in the same [deck].
>
>I just can't seem to figure out how to implement this.


There's no way to do this 'properly' - that is, you can't have B cost
1 less when A is added. What you'll need to do is add two versions of
B - one at the original cost, one at 1 point less. Then write a
validation rule that makes sure if A is included, you use the cheaper
version - if not, you have to have the more expensive version.



--
Colen McAlister (colen@wolflair.com)
Chief Engineer, Lone Wolf Development
http://www.wolflair.com/
 
You must log in or register to reply here.
Back
Top