• Please note: In an effort to ensure that all of our users feel welcome on our forums, we’ve updated our forum rules. You can review the updated rules here: http://forums.wolflair.com/showthread.php?t=5528.

    If a fellow Community member is not following the forum rules, please report the post by clicking the Report button (the red yield sign on the left) located on every post. This will notify the moderators directly. If you have any questions about these new rules, please contact support@wolflair.com.

    - The Lone Wolf Development Team

Changing Model Count Question

  • Thread starter Thread starter cshumack at bellsouth.net
  • Start date Start date
C

cshumack at bellsouth.net

Guest
I am using a model count routine in my data file. I have several
parent units that I use as HQ or Troops choices that I want to show
name only with no model count. The models are added below the parent
unit name as child units. I was able to do this with one of my child
units with no models that had sub-child units with models, but I
can't seem to get a parent unit to show 0 in the ## column. Is this
possible with parent units? If so, how do I do this? I tried
inputing "0:0" in the size attribute.


-------------------------- eGroups Sponsor -------------------------~-~>
eLerts
It's Easy. It's Fun. Best of All, it's Free!
http://click.egroups.com/1/9699/1/_/36190/_/975449794/
---------------------------------------------------------------------_->

To unsubscribe from this group, email

armybuilder-unsubscribe@egroups.com
 
By default, AB does not allow the size to go to zero. To enable this,
assign the "zero" attribute to the unit.

Thanks, Rob


At 10:15 PM 11/28/00 +0000, you wrote:
>I am using a model count routine in my data file. I have several
>parent units that I use as HQ or Troops choices that I want to show
>name only with no model count. The models are added below the parent
>unit name as child units. I was able to do this with one of my child
>units with no models that had sub-child units with models, but I
>can't seem to get a parent unit to show 0 in the ## column. Is this
>possible with parent units? If so, how do I do this? I tried
>inputing "0:0" in the size attribute.


---------------------------------------------------------------------------
Rob Bowes (rob@wolflair.com) (650) 726-9689
Lone Wolf Development www.wolflair.com

-------------------------- eGroups Sponsor -------------------------~-~>
eLerts
It's Easy. It's Fun. Best of All, it's Free!
http://click.egroups.com/1/9699/1/_/36190/_/975450504/
---------------------------------------------------------------------_->

To unsubscribe from this group, email

armybuilder-unsubscribe@egroups.com
 
You must log in or register to reply here.
Back
Top