Junior Member
Join Date: Oct 2009
Posts: 3
|
Hello, I recently ran into a problem with Army builder where I cannot get the program to 'reopen' after I've used the program once and closed it. I always get the error.
The data files couldn't be loaded for the following reasons Out of System resources. My computer is running the 64 bit version and I have 4 GB of ram and plenty of hard drive. So what is going on, because I can re-install the program and get 1 good use out of it? |
#1 |
Junior Member
Join Date: Oct 2009
Posts: 1
|
I have the same problem.
I'm running a Samsung NC10 netbook with 1Gb ram and 32bit Windows 7 Ultimate. Any help would be much appreciated. |
#2 |
Junior Member
Join Date: Oct 2009
Posts: 1
|
Same thing for me too - worked fine under 3.1, but 3.2 appears to not work under Win7?
|
#3 |
Senior Member
Join Date: Dec 2005
Location: Thunder Bay, ON, Canada
Posts: 158
|
I had problems at first as well but if I remember correctly I changed it to run in compatibility mode. But I had problems with Windows 7 so I dumped. I'll try it out again perhaps after Service Pack 1 is released.
|
#4 |
Junior Member
Join Date: Oct 2009
Posts: 2
|
Hello
I have a similar problem with Windows 7 64bits I can't activate Army Builder 3.1 even if i have always one licence available. The other licence works well on Win XP SP2 32bits with Army Builder 3.1. I check on Lone Wolf licence site admin : one A.B 3.1 licence already available but no way to install it on win7 I don't known if AB 3.2 is better with Windows 7. Looking others posts, it seems that its does works correctly, bad news Last edited by Tynethe; October 21st, 2009 at 02:22 PM. |
#5 |
Senior Member
Lone Wolf Staff
Join Date: May 2005
Posts: 13,214
|
Tynethe, do you mean you have AB operating on one computer, and you can't install AB on a second computer? If so, have you gone through the second license procedure in the license menu (in your original copy of AB)?
(sorry I can't help the rest of you - Rob and Colen know how the program is written, and have access to computers with Win7, but it sounds like Tynethe might have a different problem that I do know the answer to). |
#6 |
Junior Member
Join Date: Oct 2009
Posts: 2
|
Hi
Thanks Mathias, you right i wasn't using the second license procedure, using this menu its works. Sorry for this miss understanding. Just one other question : to use the new version 3.2a, i have to buy it isn't a extension Thanks again. |
#7 |
Junior Member
Join Date: Oct 2009
Posts: 3
|
Matthais,
Could you then please pose the question to those 2? |
#8 |
Senior Member
Lone Wolf Staff
Join Date: May 2005
Posts: 13,214
|
Quote:
I've forwarded it. I would presume they've seen it and were still studying the problem, or that gilvagor's suggestion of compatability mode was the correct solution, so there was no need to post and say the same thing. |
|
#9 |
Junior Member
Join Date: Oct 2009
Posts: 3
|
Matthais,
I think the compatibility is the answer...thank you very much. |
#10 |
|
|