Printer Output

KaitlynStuart · July 23rd, 2008, 07:13 PM

I'm wondering if it's possible to manipulate the printed output of the program -- I'd like to tweak the M&M statblocks a little bit to better suit my tastes. Is this possible? It seems like it -- everything's XML-based -- but I'm not entirely certain where to start.

Thanks!

Mathias · July 23rd, 2008, 09:01 PM

As I understand it from what I've read on these forums, not yet, but the capability is planned for the authoring kit that's being worked on now.

KaitlynStuart · July 24th, 2008, 06:17 AM

Ok, great. Thank you very much!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

KaitlynStuart Junior Member Join Date: Jul 2008 Posts: 17 July 23rd, 2008, 07:13 PM	I'm wondering if it's possible to manipulate the printed output of the program -- I'd like to tweak the M&M statblocks a little bit to better suit my tastes. Is this possible? It seems like it -- everything's XML-based -- but I'm not entirely certain where to start. Thanks!
#1

Mathias Senior Member Lone Wolf Staff Join Date: May 2005 Posts: 12,898 July 23rd, 2008, 09:01 PM	As I understand it from what I've read on these forums, not yet, but the capability is planned for the authoring kit that's being worked on now.
#2