Mr. Error here...

Evil Curt · December 11th, 2009, 10:33 PM

Some guys get to be chick magnets...I get to be an error magnet! Anyway, I at least wrote this one down as well. I had made three characters. I had saved them in the tac console. I then went to make "the thing" and then wanted to import it into the tac con. I got the following message...
C:\herolab\herolab.exe3.5 203 integer divide by zero address 0x0056d31a parameter count:0 The program shut down. I then reloaded the program and noticed that the tac con tab also came up with the program. This time, I shut down the tac con, and made "the thing" and was able to get it to go into the tac con with no problem...

Anyway, thanks for looking at this... take care...Curt

rob · December 14th, 2009, 07:44 PM

As with the previous problem you reported, could you please send me the portfolios that are causing the problem? If you can provide each of the portfolios involved in the crash you described above, along with instructions on how to re-create the crash, that would be awesome. Then we can reproduce the problem here and get it fixed in the next update. :-)

rob Senior Member Lone Wolf Staff Join Date: May 2005 Posts: 8,232 December 14th, 2009, 07:44 PM	As with the previous problem you reported, could you please send me the portfolios that are causing the problem? If you can provide each of the portfolios involved in the crash you described above, along with instructions on how to re-create the crash, that would be awesome. Then we can reproduce the problem here and get it fixed in the next update. :-)
#2