Senior Member
Join Date: Aug 2008
Location: Miamisburg, OH
Posts: 1,322
|
Qucick question, how can i get the pre-reqs for a class show up in the Class Windows when i try to select it to level up? I have created 2 prestige clases and niether of them seem to show the pre-reqs. Any thoughts? Thanks.
|
#1 |
Senior Member
Lone Wolf Staff
Join Date: May 2005
Posts: 13,213
|
You put the prereqs on the class level, rather than the class helper, right?
Try adding a level of the class to a new character - do the prereqs show up in the validation list? |
#2 |
Senior Member
Join Date: Aug 2008
Location: Miamisburg, OH
Posts: 1,322
|
The pre-reqs were added to the Class level tab.
I wont allow me to select the class to add a level to it. i seem to meet all the requirements as well, so not sure. But if i start a level 1 character it should dicplay all the pre-reqa in red as i pass over the class list that shows up when i select level Up. I'm not seeing anything there for pre-reqs. |
#3 |
Senior Member
Lone Wolf Staff
Join Date: May 2005
Posts: 13,213
|
What error does it give you when you try to add those levels? Even if it's grayed out, you should be able to add levels. The only thing that should absolutely prevent you from adding levels in a class is the max limit field on the class level (right-hand side, around the middle), but that value is something you set on the create class dialog - and it defaults to 10 levels, so there isn't supposed to be a problem even if you don't change the value.
|
#4 |
Senior Member
Join Date: Aug 2008
Location: Miamisburg, OH
Posts: 1,322
|
I think i figured it out. I wasn;t putting in a message on the pre-req panel. Sorry about that.
|
#5 |
|
|