Lone Wolf Development Forums  

Go Back   Lone Wolf Development Forums > Card Vault Forums > Card Vault

Notices

Reply
 
Thread Tools Display Modes
ratboy
Member
Volunteer Data File Author
 
Join Date: May 2005
Location: Cedar Grove, NJ USA
Posts: 85
Send a message via ICQ to ratboy Send a message via AIM to ratboy

Old September 25th, 2005, 10:40 PM
In adding a new set to the SW CMG files, I've come upon a dilemma.

FIG A makes FIG B cost 1 less when they are in the same [deck].

I just can't seem to figure out how to implement this.
ratboy is offline   #1 Reply With Quote
Colen
Senior Member
Lone Wolf Staff
 
Join Date: Dec 2008
Posts: 4,690

Old September 28th, 2005, 12:47 PM
At 02:40 AM 9/26/2005 -0400, you wrote:

>In adding a new set to the SW CMG files, I've come upon a dilemma.
>
>FIG A makes FIG B cost 1 less when they are in the same [deck].
>
>I just can't seem to figure out how to implement this.


There's no way to do this 'properly' - that is, you can't have B cost
1 less when A is added. What you'll need to do is add two versions of
B - one at the original cost, one at 1 point less. Then write a
validation rule that makes sure if A is included, you use the cheaper
version - if not, you have to have the more expensive version.



--
Colen McAlister (colen@wolflair.com)
Chief Engineer, Lone Wolf Development
http://www.wolflair.com/
Colen is offline   #2 Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 10:03 AM.


Powered by vBulletin® - Copyright ©2000 - 2024, vBulletin Solutions, Inc.
wolflair.com copyright ©1998-2016 Lone Wolf Development, Inc. View our Privacy Policy here.