At 02:40 AM 9/26/2005 -0400, you wrote:
>In adding a new set to the SW CMG files, I've come upon a dilemma.
>
>FIG A makes FIG B cost 1 less when they are in the same [deck].
>
>I just can't seem to figure out how to implement this.
There's no way to do this 'properly' - that is, you can't have B cost
1 less when A is added. What you'll need to do is add two versions of
B - one at the original cost, one at 1 point less. Then write a
validation rule that makes sure if A is included, you use the cheaper
version - if not, you have to have the more expensive version.
--
Colen McAlister (colen@wolflair.com)
Chief Engineer, Lone Wolf Development
http://www.wolflair.com/