View Single Post
Colen
Senior Member
Lone Wolf Staff
 
Join Date: Dec 2008
Posts: 4,718

Old September 28th, 2005, 01:47 PM
At 02:40 AM 9/26/2005 -0400, you wrote:

>In adding a new set to the SW CMG files, I've come upon a dilemma.
>
>FIG A makes FIG B cost 1 less when they are in the same [deck].
>
>I just can't seem to figure out how to implement this.


There's no way to do this 'properly' - that is, you can't have B cost
1 less when A is added. What you'll need to do is add two versions of
B - one at the original cost, one at 1 point less. Then write a
validation rule that makes sure if A is included, you use the cheaper
version - if not, you have to have the more expensive version.



--
Colen McAlister (colen@wolflair.com)
Chief Engineer, Lone Wolf Development
http://www.wolflair.com/
Colen is offline   #2 Reply With Quote