Unfortunately, this one doesn't happen to be "normal" behavior. It's not a
matter of models being duplicated and collapsed. It's a problem with unique
ideas for tags being duplicated between the two sets of data files, so
merging them doesn't keep them separate. It should now be fixed with the
V1.1 data files...
Thanks, Rob
At 09:32 AM 9/25/2002 -0700, you wrote:
>This is likely normal behavior. Depending on the order of precedence of the
>releases, the DC release could be newer, and so will be considered the "Most
>Recent Printing" of the figure. Just turn off Settings/"Merge Duplicate Cards"
>and that should stop. You will then see both versions.
---------------------------------------------------------------------------
Rob Bowes (rob@wolflair.com) (559) 658-6995
Lone Wolf Development
www.wolflair.com
------------------------ Yahoo! Groups Sponsor ---------------------~-->
Plan to Sell a Home?
http://us.click.yahoo.com/J2SnNA/y.l...fIAA/WuQolB/TM
---------------------------------------------------------------------~->