Lone Wolf Development Forums

Lone Wolf Development Forums (http://forums.wolflair.com/index.php)
-   Card Vault (http://forums.wolflair.com/forumdisplay.php?f=17)
-   -   Help with point cost adjustment. (http://forums.wolflair.com/showthread.php?t=5814)

ratboy September 25th, 2005 11:40 PM

Help with point cost adjustment.
 
In adding a new set to the SW CMG files, I've come upon a dilemma.

FIG A makes FIG B cost 1 less when they are in the same [deck].

I just can't seem to figure out how to implement this.

Colen September 28th, 2005 01:47 PM

Help with point cost adjustment.
 
At 02:40 AM 9/26/2005 -0400, you wrote:

>In adding a new set to the SW CMG files, I've come upon a dilemma.
>
>FIG A makes FIG B cost 1 less when they are in the same [deck].
>
>I just can't seem to figure out how to implement this.


There's no way to do this 'properly' - that is, you can't have B cost
1 less when A is added. What you'll need to do is add two versions of
B - one at the original cost, one at 1 point less. Then write a
validation rule that makes sure if A is included, you use the cheaper
version - if not, you have to have the more expensive version.



--
Colen McAlister (colen@wolflair.com)
Chief Engineer, Lone Wolf Development
http://www.wolflair.com/


All times are GMT -8. The time now is 10:42 AM.

Powered by vBulletin® - Copyright ©2000 - 2020, vBulletin Solutions, Inc.
wolflair.com copyright 1998-2016 Lone Wolf Development, Inc. View our Privacy Policy here.