Help with point cost adjustment.
In adding a new set to the SW CMG files, I've come upon a dilemma.
FIG A makes FIG B cost 1 less when they are in the same [deck]. I just can't seem to figure out how to implement this. |
Help with point cost adjustment.
At 02:40 AM 9/26/2005 -0400, you wrote:
>In adding a new set to the SW CMG files, I've come upon a dilemma. > >FIG A makes FIG B cost 1 less when they are in the same [deck]. > >I just can't seem to figure out how to implement this. There's no way to do this 'properly' - that is, you can't have B cost 1 less when A is added. What you'll need to do is add two versions of B - one at the original cost, one at 1 point less. Then write a validation rule that makes sure if A is included, you use the cheaper version - if not, you have to have the more expensive version. -- Colen McAlister (colen@wolflair.com) Chief Engineer, Lone Wolf Development http://www.wolflair.com/ |
All times are GMT -8. The time now is 09:01 AM. |
Powered by vBulletin® - Copyright ©2000 - 2024, vBulletin Solutions, Inc.
wolflair.com copyright ©1998-2016 Lone Wolf Development, Inc. View our Privacy Policy here.